TenTec
[Top] [All Lists]

[TenTec] OMNI D 546 Series A mods?

To: <tentec@contesting.com>
Subject: [TenTec] OMNI D 546 Series A mods?
From: n4lq@iglou.com (n4lq@iglou.com)
Date: Tue, 20 Aug 2002 12:30:59 -0400
Model A had an "analog" display...Non Digital.
Model D had a "digital" display
Model D had 2 series, B and C. 
Going from model A to model D series B would require installation of a 
frequency counter. Not really practical. 


Steve N4LQ

-----Original Message-----
From: "Ron McConnell" <rcmcc@earthlink.net>
To: "Ten-Tec list" <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Tue, 20 Aug 2002 11:57:49 -0400
Subject: [TenTec] OMNI D 546 Series A mods?

> 
> The Ten-Tec FAQ page address I have
> http://www.contesting.com/TenTecFAQ.html
> comes up "Invalid Page Location."
> 
> I find myself the surprised owner of
> an OMNI D 546 Series A rig, courtesy
> of a ham who gave it a non-ham buddy
> of mine who then gave it to me.
> I got the manual and a power cord from Ten-Tec.
> 
> Since there was at least a Series B,
> I assume that there are mods to Series A.
> Any suggestions on what are the
> "low hanging fruit" mods and where
> to find info on them?
> 
> Thanks.
> 
> Cheers,
> 
> Ron McConnell
> w2iol
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


<Prev in Thread] Current Thread [Next in Thread>