TenTec
[Top] [All Lists]

[TenTec] Vertical Ant. Question / Suggestion

To: <tentec@contesting.com>
Subject: [TenTec] Vertical Ant. Question / Suggestion
From: wb2vuf@qsl.net (Bwana Bob)
Date: Wed, 28 Aug 2002 21:57:18 -0400
Gordon:

There are a number of decent verticals on the market, but they are only
as good as the radials or ground plane under them. However, you don't
really need 120 radials as some of the purists may say. The law of
diminishing returns kicks in at around 30 radials.

I recently replaced my G5RV antenna with 2 antennas: One is an 80 meter
1/4 wave inverted "L" which is about 16 feet high and runs 50 feet from
the house to a tree. The other is a vertical loop cut for 40 meters. The
bottom of the loop runs along my fence at about 8 feet high. Length to a
tree is again about 50 feet. It is fed with a short piece of 450 ohm
line to a 4:1 balun. With a tuner it performs well on all bands 40
meters and above.

Once the copper wire tarnishes it turns brown and is virtually
invisible. Not so with verticals unless you disguise or paint them.

                                73,

                                Bob WB2VUF



Gordon Saunders wrote:
> 
> Greetings Ten-Tec'ers,
> 
> My ol' G5RV finally came down in the last storm through here ... served me
> well it did.
> Thinking of putting up a Vertical to try my luck there. Working on USA-CA
> Award .. Hi Hi
> 
> Requirements:
> 
> Stealth ... all the usual stuff my neighborhood seems to think is the law.
> 
> Mostly 20 meter work ...  14.336  .. county hunters
> 
> Low cost ... son in NC State University .. you know the story there.
> 
> Suggestions ??
> I'm running a Omni D  100 watts
> Out of the box type that have worked well for you.
> Home-brew is highly possible .. leads to that route?
> 
> Thanks for your time and help
> 
> Gordon Saunders  KW4CZ
> Greensboro, NC
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>