TenTec has posted an update (version 1.01) to the Argo V firmware on their
website
http://www.tentec.com/rfsquared
Here's their description of the update:
V1.01 12/5/02 Maintenance release
Fixed EEPROM write bug which caused intermittent SPLIT LED.
Now ignore SCAN key during KEYR or VOX key menus.
Fixed bug: Both VFOS out-of-band, BAND key seemed to stop working.
Changed reset default for VOX HANG from "1" to "0" to enable QSK.
Finalized RS-232 interface command set and Programmer's Ref. Manual.
Fixed bug which could cause incorrect VFO A frequency on powerup.
The programmer's reference guide is also available at the same site,
although I was unable to download it this morning (I kept getting a 404
error)
73,
Mark, N8ME
|