THAT is a VERY good question.
Or more to the point, why isn't there a standard Ten-Tec command set
that each radio must talk,and if it cant execute a command, it spits out
an error or closely approximates the action (i.e. synchonous AM)
Or even better...a standardised amatur radio command set?
I know I know this isn't professsional, military radio technology we're
using, but maybe we should strive for that kind of usefulness.
Ohh...sorry. I'll wake up now, and go play with my knobs and wheels.
-Dan
9w2du/n7nmd
(never email when in a bad mood..sorry! :)
N4PY wrote:
>I just took a look at the programmer's reference manual for the Argo V.
>Two things surprised me. The serial port baud rate is 1200 baud!
>And different from the pegasus and jupiter, to set a different transmit and
>receive frequency, you set vfo B to the transmit frequency, VFO A to
>the receive frequency, and send a command to turn on split. In the pegasus,
>you just set a transmit frequency and a receive frequency. Why is it that
>every tentec radio has a different command set requiring unique programming
>to control it?
>
>
>Carl Moreschi N4PY
>
>----- Original Message -----
>From: "Mark Erbaugh" <mark@microenh.com>
>To: <tentec@contesting.com>
>Sent: Tuesday, December 10, 2002 7:39 AM
>Subject: [TenTec] New Argo V Firmware V1.01 Posted
>
>
>
>
>>TenTec has posted an update (version 1.01) to the Argo V firmware on their
>>website
>>
>>http://www.tentec.com/rfsquared
>>
>>Here's their description of the update:
>>
>>V1.01 12/5/02 Maintenance release
>>
>> Fixed EEPROM write bug which caused intermittent SPLIT LED.
>> Now ignore SCAN key during KEYR or VOX key menus.
>> Fixed bug: Both VFOS out-of-band, BAND key seemed to stop working.
>> Changed reset default for VOX HANG from "1" to "0" to enable QSK.
>> Finalized RS-232 interface command set and Programmer's Ref. Manual.
>> Fixed bug which could cause incorrect VFO A frequency on powerup.
>>
>>
>>The programmer's reference guide is also available at the same site,
>>although I was unable to download it this morning (I kept getting a 404
>>error)
>>
>>73,
>>Mark, N8ME
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
|