TenTec
[Top] [All Lists]

[TenTec] Omni VI encoder

To: <tentec@contesting.com>
Subject: [TenTec] Omni VI encoder
From: adb1x1@yahoo.com (Anthony Bowyer)
Date: Thu Feb 20 11:39:04 2003
Mark,
  I was able to use a small mechanical encoder that
came from an Icom IC-728 on my Omni V. I had to pull
the encode lines high with resistors, but it worked
fine. I couldn't detect any problems with missed
pulses, etc. I assume the Omni VI arrangement for the
301 is the same. I've been looking for a decent knob
that doesn't cost as much as the encoder!

Anthony

=====
NT4X

__________________________________________________
Do you Yahoo!?
Yahoo! Tax Center - forms, calculators, tips, more
http://taxes.yahoo.com/
<Prev in Thread] Current Thread [Next in Thread>