I will have version 2.08 of my N4PY Pegasus/Jupiter control program out on
June 1. It will have full support for the 60 meter band for the Pegasus and
Jupiter.
Carl Moreschi N4PY
----- Original Message -----
From: "Jim FitzSimons" <cherry@getnet.net>
To: <tentec@contesting.com>
Sent: Thursday, May 15, 2003 12:48 PM
Subject: Re: [TenTec] Re: CW on 60M
> Is there a link to the new information of the 60M allocation?
> When will it be open for us in the US?
> Will the N4PY software support a the 60M band?
> Jim W7ANF
>
> ----- Original Message -----
> From: "N4PY" <n4py@qvssoftware.com>
> To: <tentec@contesting.com>
> Sent: Thursday, May 15, 2003 5:21 AM
> Subject: Re: [TenTec] Re: CW on 60M
>
>
> > That's not true. Sending an audio tone would be indistinguishable from
a
> > CW carrier and in clear violation of the rule.
> >
> > Carl Moreschi
> >
> > ----- Original Message -----
> > From: "Roy Koeppe" <royanjoy@ncn.net>
> > To: "Ten Tec Reflector" <tentec@contesting.com>
> > Sent: Thursday, May 15, 2003 7:44 AM
> > Subject: [TenTec] Re: CW on 60M
> >
> >
> > > About...
> > >
> > > "BTW, you CAN send CW on these bands... you would just need to have
> > > audio
> > > keying on a USB transmission... which is supported via some soundcard
> > > software like MixW. It certainly meets the letter of the law."
> > >
> > > A single frequency audio tone fed into the mike jack of a SSB
> > > transmitter produces a normal CW signal at the antenna. I guess that
was
> > > tongue in cheek though...
> > >
> > > 73, Roy K6XK/0
> > >
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|