TenTec
[Top] [All Lists]

[TenTec] HP GPS Receiver

To: <tentec@contesting.com>
Subject: [TenTec] HP GPS Receiver
From: mark@microenh.com (Mark Erbaugh)
Date: Fri Jun 20 09:44:16 2003
Eric,

Thanks - but does the antenna need a ground plane? I suspect it was designed
to mount on a vehicle roof which would act as a GP. On the K8CU website, one
person mentioned mounting in a pie plate or such.  I received no
instructions with my antenna.

73,
Mark

----- Original Message -----
From: "Eric Scace K3NA" <eric@k3na.org>
To: <tentec@contesting.com>
Sent: Friday, June 20, 2003 9:15 AM
Subject: RE: [TenTec] HP GPS Receiver


> In most installations the hockey puck antenna is attached to the top of a
stick/pipe/tube.  The antenna needs to be in a location
> where it can see the maximum amount of sky.  Even tree foliage will block
the GPS signals.
>
> 73,
>    -- Eric K3NA
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Mark Erbaugh
> Sent: 2003 June 19 Thursday 23:25
> To: tentec@contesting.com
> Subject: Re: [TenTec] HP GPS Receiver
>
>
> I got my Z3801 yesterday and checked it out.  How/where did you install
the
> antenna? I think I need to put the antenna on the roof so that the house
> doesn't block the sky. For testing purposes I set the antenn in the front
> yard (as far as the 20' cable would go) and it could only acquire 2
> satellites, which isn't enough to do a survey and set the new position.
Does
> the antenna need to be mounted on a metal ground plane?
>
> 73,
> Mark
> ----- Original Message -----
> From: "Carl Moreschi" <n4py@earthlink.net>
> To: <tentec@contesting.com>
> Sent: Thursday, June 19, 2003 19:44 PM
> Subject: [TenTec] HP GPS Receiver
>
>
> > I received my HP GPS receiver today.  I have it all installed.  I used
> Jim's
> > method to hook it up to the rs232 port to the computer and it works
fine.
> I
> > now have a 10 mhz frequency standard that sets my rx340 exactly on
> > frequency.
> >
> > My N4PY Orion Control Program is just about ready for prime time.  I
have
> it
> > working with the remote tuning pod and things are looking great.
> >
> > Carl Moreschi N4PY
> > Franklinton, NC
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

<Prev in Thread] Current Thread [Next in Thread>