TenTec
[Top] [All Lists]

Re: [TenTec] Omni D frequency shifting

To: tentec@contesting.com
Subject: Re: [TenTec] Omni D frequency shifting
From: Clark Savage Turner <csturner@slonet.org>
Reply-to: tentec@contesting.com
Date: Tue, 24 Jun 2003 06:22:40 -0700
List-post: <mailto:tentec@contesting.com>
Sure sounds like a PTO rebuild to me. Does the frequency shift on receive by any noticeable amount? 20 Hz is pretty hard to detect by ear, but if you set the OMNI on some stable CW station, listen to see if it shifts up and down here and there. I have had these symptoms and the PTO mechanics were at fault, easy to fix by clean and repair.

The other possibilities include the bandswitch (move it back and forth a few times to see if it temporarily cures the problem) and there are some board connections that could possibly need cleaning (try reseating all the connectors and even the boards themselves just as a point of maintenance).

Very good luck to you sir.  Write again if the problem persists.

Clark
WA3JPG


On Tuesday, June 24, 2003, at 04:25 AM, Tony wrote:

Hi Ten Tec Gurus
I've just had reports on 14 MHz that my OMNI D is shifting freq by 20 Hz "at random", I'm hoping that this is known fault and is simple to fix ?

I'd appreciate any assistance
73  Tony G3ZRJ

<Prev in Thread] Current Thread [Next in Thread>