TenTec
[Top] [All Lists]

Re: [TenTec] need help

To: <tjednacz@ieee.org>, <tentec@contesting.com>
Subject: Re: [TenTec] need help
From: "jack" <jfriend31@comcast.net>
Reply-to: tentec@contesting.com
Date: Sun, 12 Oct 2003 20:51:56 -0600
List-post: <mailto:tentec@contesting.com>
here are the settings: orion set according to the latest manual suggestions
except for mike gain which i cannot find on the radio ...besides having no
mike for the orion anyway ...

i changed the setting of com1 (to which the orion is connected) to 57600 and
unchecked the buffers ...

in MixW2 CONFIGURE

sound card settings input and output SB Live
otherwise on sound card settings default

output volume auxiliary up as far as it goes, same for microphone and
line-in

input volume microphone select and all the way up

i can copy psk31 but cannot transmit at all

again there is no PTT connection at all on the rig
VOX is on

tnx jack ak7o

PS: the nearly 24 hours of trying to load 1.358 did not work ...after
processing all those lines of code the message came up saying that there was
no way to be sure that the firmware was updated without error checking
...clearly it did not work since the startup screen shows 1.356 still




----- Original Message ----- 
From: "Thomas Jednacz" <tjednacz@ieee.org>
To: <tentec@contesting.com>
Sent: Sunday, October 12, 2003 4:22 PM
Subject: RE: [TenTec] need help


> Set your com port to 57600 speed and go to the advance tab and turn off
> buffers. Try it again. I am running XP Pro and it works fine.
>
> Tom, W7QF
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of jack
> Sent: Saturday, October 11, 2003 23:18 PM
> To: tentec@contesting.com
> Subject: [TenTec] need help
>
>
> i downloaded the latest update for the Orion ...can't get the update to
talk
> to the Orion thru com1 or com2 ...both com ports work fine with other
> peripherals ...i run hostmaster 2 plus to control a KAM Plus and can use
> either port for that depending on how i plug the KAM into the computer. i
am
> running WinXP home and it indicates the ports work fine, but every time i
> try to run the update for the Orion i get an error message or the update
> locks up and stops running ...any ideas? thanks jack ak7o
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>