S/N 06C10573
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Jason Buchanan
Sent: Saturday, October 18, 2003 13:12
To: tentec@contesting.com
Subject: Re: [TenTec] big Orion problem
What serial numbers do you guys have?
Sounds like differences in hardware..........
73 - Jason W0JSB
Ron Martin wrote:
> Just For The Record, mine is working as described below.. Prior to
> the upgrade, the radio ran smooth as silk. Upgrade resulted in
> problems.
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]
> On Behalf Of Grant Youngman
> Sent: Saturday, October 18, 2003 09:05
> To: tentec@contesting.com
> Subject: RE: [TenTec] big Orion problem
>
>
> Just for the record, mine has been working smooth as silk since the
> upgrade with no problems.
>
> Grant/NQ5T
>
>
>>I upgraded, did all of the resets, and the darn thing randomly fails.
>>The random failure on turn on is that it either comes up locked up
>
> and
>
>>transmitting or is locked up.
>>
>>Went through the resets again (and again and again, etc.),
>
> sometimes
>
>>comes up running correctly or the darn thing is locked out.
>>
>>Had no problems like this prior to the upgrade.....
>>
>>
>>Ron ....... NU1U
>>
>>-----Original Message-----
>>From: tentec-bounces@contesting.com
>>[mailto:tentec-bounces@contesting.com] On Behalf Of jack Sent:
>
> Friday,
>
>>October 17, 2003 16:21 To: tentec@contesting.com Subject:
>
> [TenTec] big
>
>>Orion problem
>>
>>
>>i downloaded and updated my Orion to 1.363 ...then did a RESET
>
> with
>
>>MAIN RX/TX ...the frequency is 14.250 USB but NONE of the
>
> knobs
>
>>buttons works ...
>>
>>called Ten Tec ...redo the update was the suggestion ...
>>
>>update again using Com2 this time ...with all other software shut
>
> down
>
>>and after rebooting the computer (running WinXP) same result
>>
>>NO AUDIO tho the S-meter kicks from noise or signal ...again
>
> none of
>
>>the buttons/knobs work except the power switch and booting with
>
> either
>
>>MAIN RX/TX or VFOB LCK ...still no audio or anything else
>>
>>any suggestions?
>>
>>jack ak7o
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
> -------------------------------
> Grant Youngman /NQ5T
> http://www.globeking.com
> nq5t@comcast.net < == NEW
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|