serial number 03c10693
jack ak7o
----- Original Message -----
From: "Jason Buchanan" <jsb@digistar.com>
To: <tentec@contesting.com>
Sent: Saturday, October 18, 2003 11:11 AM
Subject: Re: [TenTec] big Orion problem
>
>
>
> What serial numbers do you guys have?
>
> Sounds like differences in hardware..........
>
>
>
>
> 73 - Jason W0JSB
>
>
>
> Ron Martin wrote:
>
> > Just For The Record, mine is working as described below.. Prior to the
> > upgrade, the radio ran smooth as silk. Upgrade resulted in problems.
> >
> > -----Original Message-----
> > From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]
> > On Behalf Of Grant Youngman
> > Sent: Saturday, October 18, 2003 09:05
> > To: tentec@contesting.com
> > Subject: RE: [TenTec] big Orion problem
> >
> >
> > Just for the record, mine has been working smooth as silk since the
> > upgrade with no problems.
> >
> > Grant/NQ5T
> >
> >
> >>I upgraded, did all of the resets, and the darn thing randomly fails.
> >>The random failure on turn on is that it either comes up locked up
> >
> > and
> >
> >>transmitting or is locked up.
> >>
> >>Went through the resets again (and again and again, etc.),
> >
> > sometimes
> >
> >>comes up running correctly or the darn thing is locked out.
> >>
> >>Had no problems like this prior to the upgrade.....
> >>
> >>
> >>Ron ....... NU1U
> >>
> >>-----Original Message-----
> >>From: tentec-bounces@contesting.com
> >>[mailto:tentec-bounces@contesting.com] On Behalf Of jack Sent:
> >
> > Friday,
> >
> >>October 17, 2003 16:21 To: tentec@contesting.com Subject:
> >
> > [TenTec] big
> >
> >>Orion problem
> >>
> >>
> >>i downloaded and updated my Orion to 1.363 ...then did a RESET
> >
> > with
> >
> >>MAIN RX/TX ...the frequency is 14.250 USB but NONE of the
> >
> > knobs
> >
> >>buttons works ...
> >>
> >>called Ten Tec ...redo the update was the suggestion ...
> >>
> >>update again using Com2 this time ...with all other software shut
> >
> > down
> >
> >>and after rebooting the computer (running WinXP) same result
> >>
> >>NO AUDIO tho the S-meter kicks from noise or signal ...again
> >
> > none of
> >
> >>the buttons/knobs work except the power switch and booting with
> >
> > either
> >
> >>MAIN RX/TX or VFOB LCK ...still no audio or anything else
> >>
> >>any suggestions?
> >>
> >>jack ak7o
> >>
> >>_______________________________________________
> >>TenTec mailing list
> >>TenTec@contesting.com
> >>http://lists.contesting.com/mailman/listinfo/tentec
> >>
> >>
> >>_______________________________________________
> >>TenTec mailing list
> >>TenTec@contesting.com
> >>http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> >
> >
> > -------------------------------
> > Grant Youngman /NQ5T
> > http://www.globeking.com
> > nq5t@comcast.net < == NEW
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|