Just for the record, mine has been working smooth as silk since the
upgrade with no problems.
Grant/NQ5T
> I upgraded, did all of the resets, and the darn thing randomly fails.
> The random failure on turn on is that it either comes up locked up
and
> transmitting or is locked up.
>
> Went through the resets again (and again and again, etc.),
sometimes
> comes up running correctly or the darn thing is locked out.
>
> Had no problems like this prior to the upgrade.....
>
>
> Ron ....... NU1U
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of jack Sent:
Friday,
> October 17, 2003 16:21 To: tentec@contesting.com Subject:
[TenTec] big
> Orion problem
>
>
> i downloaded and updated my Orion to 1.363 ...then did a RESET
with
> MAIN RX/TX ...the frequency is 14.250 USB but NONE of the
knobs
> buttons works ...
>
> called Ten Tec ...redo the update was the suggestion ...
>
> update again using Com2 this time ...with all other software shut
down
> and after rebooting the computer (running WinXP) same result
>
> NO AUDIO tho the S-meter kicks from noise or signal ...again
none of
> the buttons/knobs work except the power switch and booting with
either
> MAIN RX/TX or VFOB LCK ...still no audio or anything else
>
> any suggestions?
>
> jack ak7o
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
-------------------------------
Grant Youngman /NQ5T
http://www.globeking.com
nq5t@comcast.net < == NEW
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|