Thanks for all of the feedback regarding my rig control question. I have
connected my Omni to the COMM1 port via the 25 pin cable. After doing the port
selection criteria in my Writelog program, the only rig information that I have
on my screen is frequency and mode. Adjusting these parameters requires either
manual action on the computer (new frequency/mode entry via a window) or
adjustment at the rig on the tuning knob. Any adjustments to any other
parameter, such as power level, AF gain, etc. still must be done at the radio
and are not visible on the screen. It would sure be great to totally control
the radio from the computer. Any ideas of what I am doing wrong with either
the Writelog program or my interface set-up? Thanks in advance. 73.
George W6AEA
w6aea@msn.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|