In a message dated 12/02/2003 10:37:26 Eastern Standard Time,
jpfeifer@gci.net writes:
<< When I crank in any filtering below 1.8 kHz, however, all of the signals
are attenuated to the point that I can't hear anything. >>
This brings back some old memories. When I added a bunch of filters to my
Argosy I had the same problem till I did a little alignment to get everything
on
the same frequency and to allow maximum signal transfer. I believe the guys
at Sevierville talked me through this procedure which I was able to do with
minimal test gear.
73, Blair k3yd
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|