TenTec
[Top] [All Lists]

RE: More Re: [TenTec] Orion redefines the meaning of ... AGC OFF

To: <tentec@contesting.com>
Subject: RE: More Re: [TenTec] Orion redefines the meaning of ... AGC OFF
From: "Rick Westerman" <Rick@dj0ip.de>
Reply-to: Rick@dj0ip.de, tentec@contesting.com
Date: Sun, 8 Feb 2004 21:26:17 +0100
List-post: <mailto:tentec@contesting.com>
Hey Sinisa, what in the world are you trying to prove now?

"Can I recommend a more repeatable noise figure test,
which even doesn't require any signal on the band?"

What is your point?  Who among us is interested in tests which do
not require a signal on the band.  I assume we are all in this
game to hear signals on the band.  What you are suggesting is
nothing more than mental masturbation.  Sorry for the French but
that's the only words I can find for this situation!

Sorry Sinisa, this time I just can't see your point!

73
Rick



-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Sinisa Hristov
Sent: Sunday, February 08, 2004 4:07 PM
To: tentec@contesting.com
Subject: Re: More Re: [TenTec] Orion redefines the meaning of ...
AGC
OFF


Carl Moreschi wrote:

> With the preamp on, the signal jumps up a lot in audio
> volume.  This is a symptom of insufficient gain.

Increase in audio volume demonstrates only that
the preamp has some gain, with AGC threshold
not reached without preamp. Nothing more and nothing
less than that. Taken alone, this says nothing
about receiver quality, sufficiency of gain, etc.

Your test also compares signal to noise ratio with preamp off,
concluding that K2 produces bad S/N with preamp off.
This is a meaningful test comparing receivers'
noise figures with preamp off. Orion's active mixer
can reasonably be expected to have a better noise figure
than K2's passive mixer.

Can I recommend a more repeatable noise figure test,
which even doesn't require any signal on the band?

Please test for the difference in noise level
with antenna connected and disconnected
(Strictly speaking, antenna shall be replaced by a 50 Ohm
termination).
Meaningful compare requires that AGC threshold is not exceeded.

Sufficiently low noise figure is indicated by a 10-12 dB
increase in audio noise with antenna connected.
Anything more than that is useless, while lower values indicate
that receiver's internal noise will mask some of the signal.


> K2 is much poorer voice quality than the Orion listening to SSB
signals.
> This is because the K2 ssb filter is too narrow.

And probably not as flat as Orion's DSP filters.
In-band flatness is even more important for perceived
voice quality, than the bandwith alone.


> It is much easier to get good IP3 and BDR numbers if you design
with a low
> overall gain factor.

It's also easier to get bad IP3 if one designs with high gain,
as many other designs prove :-)


73,

Sinisa  YT1NT, VA3TTN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>