Hello , I had a 746 not a pro and did everything I could to improve the rx
audio and had no luck . I ended up trading my icom for my jupiter and I got
beauriful rx audio much better selectivity ( I had inrad filters in the
icom ) and a noise reduction that really WORKS nice ! my advise is go with
the Jupiter and get the n4py software to run it you will end up with two
radios . I loaded over a hundread shortwave listing freqs. on the n4py
software and it works fantastic with the jupiter . good luck John
----- Original Message -----
From: "Bruce Multhup" <brucem@woh.rr.com>
To: <tentec@contesting.com>
Sent: Monday, February 23, 2004 9:27 AM
Subject: [TenTec] Jupiter vs 746 PRO
> Need some help guys. I am think of purchasing the Icom 746 PRO but I
> have heard about all the transmit problems. So several comments have led
> me to the Jupiter radio. I have never owned a Ten Tec before so I really
> don't know much about them. My concern is that the specs for the Jupiter
> on receive sensitivity is not as good as the 746 PRO. This concerns me
> because I like to work 80 meters DX and signals are not that strong. Any
> comments folks and thanks.
>
> Bruce
> N8CZZ
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|