Re: [TenTec] Orion Notes, High/Low Cut

[K4IA@aol.com]

In a message dated 5/20/2004 22:44:06 PM Eastern Daylight Time, 
w4tje@mindspring.com writes:
when qrm comes on above my freq. I tighten up 
the high cut filter, and then push the knob, holding it down for several 
seconds. The action created by pushing in and holding the knob is much more 
dramatic and effective than by only turning to tighten the filter. 
I can;t duplicate this.  What does the BW, PBT and RIT readout say before and 
after you push the button?


Radio k4ia
"Buck"
Fredericksburg, Virginia USA