What do you want with the right side audio anyway???
There was a time when I wanted it but determined later (after I managed to
fabricate a cable) that it wasn't needed afterall.....
----- Original Message -----
From: <N0KHQ@aol.com>
To: <toby423@earthlink.net>; <tentec@contesting.com>
Sent: Sunday, June 06, 2004 4:14 PM
Subject: [TenTec] Orion Aux I/O
> Well Toby, its not going to be as simple as I first thought.
>
> The Aux I/O on the Orion is an 8 pin din. The cable as supplied by TT is a
5
> pin din with 4 RCA plugs on it and is a molded connector. So any hopes of
> modifying the existing cable isnt going to work.
>
> So, I'll send TT an email asking for the correct cable. I may end up
making
> my own.....we'll see.
>
> It sure would have been nice if the manual would have said.....this is
what
> we're sending and if you want to do this......your on your own.
>
> TT did send an 8 pin din plug.......but left out the 7 RCA plugs and
wiring I
> will need.
>
> Back to Radio Shack.
>
> Not complaining.......just an observation.
>
>
> 73
> John / N0KHQ / St. Louis
>
> Always on 18.130
>
> Antennas:
>
> You can build 'em better than you can buy 'em
> Please visit the sites below:
> http://www.hamuniverse.com/17mcoaxmox.html
> http://www.cebik.com/n0khq.html
> http://www.ssb-audio.com/forum/
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|