Bernard,
My first question is...have you confirmed that your SteppIR box is a newer
one with the mod for the Orion. Back in February I was the first person
apparently to discover that the Orion and the SteppIR box would not
communicate. I sent my box back to them for a month while they worked out
a fix. The problem was that the SteppIR box was never designed to
communicate at 57,600 baud...the only comm freq for the Orion. They came
up with a new interface chip.
It finally came home to my shack after this email from Jim at Fluidmotion:
Your controller should be there soon, we included a new cable that has RTS
connected which according to one source at TEN-TEC is required. Set the
Controller to ORION with the BAUD= 57600. The Steppir controller will
Request the frequency from the Orion once every 2 seconds or so. When the
Steppir is set to General freq mode the Steppir should follow the Orion
frequency.
If the Orion needs to be connected to the Computer you will need a "Y"
cable that connects the Computer or Radio's Pin-2 to the Steppir Data IN
Pin-2 (RXD) so it can monitor the data for the frequency information. It
should also be possible to connect the Steppir Pin-2 to the Computer Pin-3
to read the set VFO command going to the Orion, this would be good for
trouble shooting.
Hopefully it will just plug and go when you get your Orion back.
Jim
The last hurdle was the requirement for the cable to include an RTS
connection. It has worked fine since then. You have to go through the
menus on the box and select the Orion option. If you don't see it, then
you don't have an updated box. I hate having to reprogram the box each
time I switch between my Yaesu Mark V and the Orion, so I just use the "ham
mode" for one or the other.
73's and hamming,
Torrey
N9PY
At 08:56 AM 7/11/2004, you wrote:
After taking "care" of a few pine trees, I finally have my new 3
element SteppIR antenna up and operational. It sure seems to work
well. The antenna patterns seem to be a little sharper than the TH-7 and
A3WS that I was using.
I also bought the Orion to SteppIR interface unit, but can't seem to
get the interface to operate properly. It seems like the two won't
communicate frequency information. I talked to Fluid Motion on Friday
and they gave me the pin out information to make sure that the interface
cable was the correct one. It checks out OK. I've been through the set
up procedure about six times, step by step. So, now, I am wondering if
it is operator error (of some type), a problem with the Orion, or a
problem with the SteppIR control box.
Anyone on the board have an Orion with the SteppIR interface who
could shed a little light on the situation. Is there a setting on the
Orion that I must activate?
73,
Bernard, WA4OEJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|