Thanks for the test.
I am able to reproduce the situation repeatably. I can also lose audio by
just pushing A>B several times, and or varying the length of time that I
hold it down.
I just turned the Orion off and back on and the condition is still there.
This time I observed that the S-Meter is still active so it appears that the
receiver is still working, just no audio.
I had all audio (left, right, speaker) routed from the main receiver.
----- Original Message -----
From: "Toby Pennington" <firstname.lastname@example.org>
Sent: Thursday, July 29, 2004 9:48 AM
Subject: Re: [TenTec] Orion loss of audio
> Mark, I tried to duplicate your loss of audio by holding down the A>B
> button but on my Orion the audio does not go away but remains stable.
> ----- Original Message -----
> From: "Mark Erbaugh" <email@example.com>
> To: <firstname.lastname@example.org>
> Sent: Thursday, July 29, 2004 9:32 AM
> Subject: [TenTec] Orion loss of audio
> > A while back, there was discussion on the reflector about complete loss
> > Orion receive audio. Was this ever resolved?
> > I have found a repeatable way to lose and recover the main receiver
> > The behaviour indicates it may be a glitch in the firmware.
> > I was listening to 40m CW on the main receiver connected to VFO A. By
> > pushing down and holding the A->B button for a second or two I can get
> > audio to go completely away (I am also monitoring the audio on the Left
> > output on the rear AUX I/O via my computer and that goes away also). By
> > pushing the A->B button I can get the audio to come back. I'm running
> > firmware version 1.371.
> > 73,
> > Mark, N8ME
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> TenTec mailing list
TenTec mailing list