TenTec
[Top] [All Lists]

Re: [TenTec] Problem with my Omni VI /option3

To: <tentec@contesting.com>
Subject: Re: [TenTec] Problem with my Omni VI /option3
From: "Chris" <christopher_an@sympatico.ca>
Reply-to: tentec@contesting.com
Date: Thu, 29 Jul 2004 22:53:49 -0400
List-post: <mailto:tentec@contesting.com>
Hi Steve,

Yes, that was the first thing I did.  It sounds like that I have to send it
to Ten-Tec.  Thanks.

Chris  VA3UT

----- Original Message -----
From: "Steve N4LQ" <n4lq@iglou.com>
To: <tentec@contesting.com>
Sent: Thursday, July 29, 2004 9:50 PM
Subject: Re: [TenTec] Problem with my Omni VI /option3


> I assume you unplugged your key and or keyer?
> Steve N4LQ
> ----- Original Message -----
> From: "Chris" <christopher_an@sympatico.ca>
> To: <TenTec@contesting.com>
> Sent: Thursday, July 29, 2004 9:01 PM
> Subject: [TenTec] Problem with my Omni VI /option3
>
>
> Hi all,
>
> I have a problem with my Omni VI/option3, and here is the symptom.
>
> When I turned on the radio yesterday, its CW sidetone was heard all the
time
> and the wattmeter was showing that it was transmitting CW signal.  None of
> the button on the mode, band, nor filter was working.  Turning the radio
off
> and on didn't fix the problem.  I did PARTIAL RESET as well as MASTER
RESET,
> but no luck at all.
>
> However, the symptom has changed after the MASTER RESET.  After this
reset,
> the radio is no longer transmitting.  I just don't hear anything from the
> radio.  The meter is moving, so I can see that the receiver is working.
If
> I do the MASTER RESET again and hold the ENTER button, I can hear signal,
> however, it goes MUTE as soon as I release the ENTER button.
>
> There is nothing connected to AUX antenna port and the meter drops when I
> press the ANTENNA button to AUX.  This assures that the receiver is
working
> but something is cutting the audio off.
>
> For both befor and after, none of the buttons works on the radio, so I
> suspect that there is a problem on the logic board or CPU of the radio.  I
> asked Ten-Tec and he also pointed that there must be a problem on the
> control board.  He told me to ship the radio, but I'd like to find if I
can
> get it fixed here locally first.  Does anyone here have any idea what went
> wrong?  Do you think I'd rather send it to Ten-Tec for repair?  I know
> Ten-Tec will do a top class work on it, but the shipping both ways will
cost
> too much.
>
> Any suggestion or comment will be much appreciated.
>
> Regards,
>
> Chris VA3UT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>