TenTec
[Top] [All Lists]

Re: [TenTec] connector type?

To: <tentec@contesting.com>
Subject: Re: [TenTec] connector type?
From: "Mike" <kc8wr@bright.net>
Reply-to: tentec@contesting.com
Date: Wed, 18 Aug 2004 19:51:29 -0400
List-post: <mailto:tentec@contesting.com>
OOPs, that was supposed to say and Omni V....I think a lot faster than I
type.

Mike - KC8WR

----- Original Message ----- 
From: "Mike" <kc8wr@bright.net>
To: <tentec@contesting.com>
Sent: Wednesday, August 18, 2004 7:47 PM
Subject: Re: [TenTec] connector type?


> Steve,
>
> If you look in a current Mouser catalog you will find AMP MTA .100
> connectors.  Those are the ones you are looking for.  I used them to
rebuild
> a Corsair and an older Omni.  I also keep a supply for projects or the
> occasional repair of  TenTec gear.  They have any size, number of pins
that
> you may need.
>
> Hope this helps....
> Mike - KC8WR
>
> ----- Original Message ----- 
> From: "n4lq" <n4lq@iglou.com>
> To: <tentec@contesting.com>
> Sent: Wednesday, August 18, 2004 10:05 AM
> Subject: [TenTec] connector type?
>
>
> > Does anyone out there know the brand name and or part number for the
> > connectors used on TenTec boards? These are the small, white connectors
> > used between circuit boards on the Paragon through Omni 6+.
> >
> > Steve N4LQ
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>