Thanks Mike. I found them 73
Steve N4LQ
----- Original Message -----
From: "Mike" <kc8wr@bright.net>
To: <tentec@contesting.com>
Sent: Wednesday, August 18, 2004 7:51 PM
Subject: Re: [TenTec] connector type?
> OOPs, that was supposed to say and Omni V....I think a lot faster than I
> type.
>
> Mike - KC8WR
>
> ----- Original Message -----
> From: "Mike" <kc8wr@bright.net>
> To: <tentec@contesting.com>
> Sent: Wednesday, August 18, 2004 7:47 PM
> Subject: Re: [TenTec] connector type?
>
>
> > Steve,
> >
> > If you look in a current Mouser catalog you will find AMP MTA .100
> > connectors. Those are the ones you are looking for. I used them to
> rebuild
> > a Corsair and an older Omni. I also keep a supply for projects or the
> > occasional repair of TenTec gear. They have any size, number of pins
> that
> > you may need.
> >
> > Hope this helps....
> > Mike - KC8WR
> >
> > ----- Original Message -----
> > From: "n4lq" <n4lq@iglou.com>
> > To: <tentec@contesting.com>
> > Sent: Wednesday, August 18, 2004 10:05 AM
> > Subject: [TenTec] connector type?
> >
> >
> > > Does anyone out there know the brand name and or part number for the
> > > connectors used on TenTec boards? These are the small, white
connectors
> > > used between circuit boards on the Paragon through Omni 6+.
> > >
> > > Steve N4LQ
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|