I know that the Argonaut has a TXCO option, but does this come standard on
the Jupiter and Orion?
On the Omni VI and VI+, the BFO board xtals are not tied into the 10 Mhz
reference xtal and are a source of frequency instability (abeit within the
rig's published specs). Do the Jupiter and/or the Orion handle this
differently so that one master frequency reference is used throughout the
rig? Do both of these rigs use a 10 Mhz reference frequency so that it
would be possible to use them with an external frequency reference (like the
surplus HPs out there)?
- jgc
John Clifford KD7KGX
Elecraft K2 #1678 /KSB2/KIO2/KBT2/KAT2/KNB2/KAF2/KPA100
Ten-Tec Omni VI/Opt1, Centaur, 238B
Alinco DR-605TQ, DJ-V5
Icom T90A
IRLP #3978
email: kd7kgx@arrl.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|