Re: [TenTec] keying loops

["Tommy" <aldermant@alltel.net>]

Grant,

I have been touching base with Carl about this for a long time. It 
is very strange that his and others, using an ACOM normally do not 
have this problem when using the Orion. Some other's have told me 
that with non-Ten Tec amps, the problem does not exist. The whole 
thing is just strange. For instance, I ran my Titan 3 with my Omni 
6, Omni 6 Plus, and my Icom IC-781 and never once had this problem. 
If we guess about this, I think you would just have to look at the 
Ten Tec amplifier face and the Orion interface do have some 
conflicts. One other interesting thread is as Bob says, he had his 
CPU/DSP board replaced in his Orion, mine was also replaced by TT at 
one time.

At any rate, some progress is finally being made, thanks to W9GE 
letting me know what he experienced back in the early part of the 
year!!

73,

Tom - W4BQF

----- Original Message ----- 
From: "Grant Youngman" <nq5t@comcast.net>
To: <tentec@contesting.com>
Sent: Monday, December 27, 2004 2:02 PM
Subject: RE: [TenTec] keying loops


> > I have always run my Orion with keying loop 1 on and keying
> > loop 2 off.  I do not have anything hooked up to keying loop
> > 2.  I have not experienced the keying loop problem with my
> > Orion and ACOM 1000.
>
> Neither have I, nor have a lot of others apparently.  But if this 
> somehow
> solves the problem that some have been experiencing, I'm all for 
> it! :-)
> And if it does, it sure would be interesting to know why ...
>
> Grant/NQ5T
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec