Don,I had an Omni 6+ with the 2,8 Inrad filters.I installed the 2.8 in place
of the factory 2.4 filters.I then installed 1.8 in both IF's for narrow SSB
reception.This leaves your other slots for CW filters if you want them.I
thought the receive was much better doing it this way.
Don
NT0F
----- Original Message -----
From: <CROCDONZ1@aol.com>
To: <tentec@contesting.com>
Sent: Wednesday, January 05, 2005 1:54 PM
Subject: [TenTec] omni 6 plus question
i have purchased and installed both of the 2.8 inrad filters. i have them
installed in the 250 hz cw and nar 2 slots. is this ok? the thing i have
observed
is when i have them selected, its like i have turned on a 10 db preamp as
well. going back to the stock 2.4 and 1.8, the s meter readings are back
in line
with all the other rigs i have. is this normal? did i do something wrong?
i
just want to be sure i am not hurting the rigs performance.
thanks
don-kd9mf
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|