IMHO, many of the 'drawings' in the manual are horribly hard to read.
----- Original Message -----
From: "A. Sewell" <n5na@att.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, March 23, 2005 19:55
Subject: Re: [TenTec] Orion Power Connector orientation
> Wow, I couldn't even see the connector orientation in my printed
> manual. Zooming in on the PDF does show it is oriented the opposite of
> the way my Orion is oriented.
>
> So....looks like the drawing needs to be fixed. It would be nice if the
> manual included a close up of the power connector.
>
> 73,
>
> Alan N5NA
>
> Grant Youngman wrote:
>
> >Either my Orion is not assembled correctly, meaning the chassis
> >connector was installed upside down, or the diagram as shown on page
> >25 of the Rev. 3 manual is incorrect. It shows the flat sides of the
> >connector closest to the cabinet edge when in fact they are oriented the
> >opposite direction (in my Orion at least). + power is on the top as
shown.
> >
> >"Trust, but verify" is the operative phrase here :-)
> >
> >-------------------------------
> >Grant Youngman /NQ5T
> >http://www.globeking.com
> >
> >_______________________________________________
> >TenTec mailing list
> >TenTec@contesting.com
> >http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|