[Top] [All Lists]

[TenTec] CENTURY 21

To: <tentec@contesting.com>
Subject: [TenTec] CENTURY 21
From: "Dave Roscoe" <w1dwz@rcn.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 10 Apr 2005 08:26:44 -0400
List-post: <mailto:tentec@contesting.com>
I need some basic info from someone who is intimately familiar with the CENTURY 
21  dial mechanism.

I just received one that is VERY clean and like new inside and out.  However, 
the dial is immovable. The dial knob turns  very freely. The setscrew is tight 
and I can see the shaft turning. It appears to me , that I am going to have to 
take the front panel off. I just did not want to go through that hassle if it 
was unnecessary .  Hope there are some  knowledgable gurus here who have been 
into the innards of this thing and can advise the road to take.

thanks in advance.

73  de Dave   W1DWZ
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>