TenTec
[Top] [All Lists]

Re: [TenTec] QSK Connecting OmniVI+ to Alpha Amp

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] QSK Connecting OmniVI+ to Alpha Amp
From: "hcrak" <hcrak@foothill.net>
Reply-to: hcrak <hcrak@foothill.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 16 May 2005 12:14:54 -0700
List-post: <mailto:tentec@contesting.com>
Thanks Rich.  Will give it a go.      73    Ken   KA6C



----- Original Message ----- 
From: "Richard Detweiler" <rdetweil@hotmail.com>
To: <hcrak@foothill.net>
Cc: <tentec@contesting.com>
Sent: Saturday, May 14, 2005 10:17 PM
Subject: Re: [TenTec] QSK Connecting OmniVI+ to Alpha Amp


> Look in the alpha web site,
>
> In their 'Tips' area is a paragraph for seting up the OMNI VI+ with 
> the
> alpha amp,  You need a Y cable with a diode isolation in the center
> connector.
>
> Best wishes.
> Rich
> K5SF
>
>>From: "hcrak" <hcrak@foothill.net>
>>Reply-To: hcrak <hcrak@foothill.net>,Discussion of Ten-Tec Equipment
>><tentec@contesting.com>
>>To: "TT reflector" <tentec@contesting.com>
>>Subject: [TenTec] QSK Connecting OmniVI+ to Alpha Amp
>>Date: Sat, 14 May 2005 19:39:23 -0700
>>
>>Help!  I recently purchased a very nice Omni VI+ but don't 
>>understand
>>instructions for keying +5VDC to ground on QSK Amp.  Can some one 
>>help
>>me with this hook-up, please??     Thanks,   Ken  KA6C
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>