TenTec
[Top] [All Lists]

Re: [TenTec] AL 811 High Input SWR with OMNI V

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] AL 811 High Input SWR with OMNI V
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
Reply-to: Steve Baron - KB3MM <SteveBaron@StarLinX.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 16 May 2005 16:36:43 -0000
List-post: <mailto:tentec@contesting.com>
Cheeck the OMI manual.  Has a standard TT blurb on how they handle high SWR.

----- Original Message ----- 
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Monday, May 16, 2005 16:43
Subject: [TenTec] AL 811 High Input SWR with OMNI V


> I bought an Ameritron AL811 Amp and hooked it up to my OMNI V.
> On 10 meters the OMNI V meter on reflected power reads a little under 3 to
1
> when I tune the amp using either the tune or a pulser.
> My antenna SWR is flat and the problem seems to be from radio to amp.
> When I go to SSB the meter on the OMNI V set to reflected reads flat.
> I can whistle into the mike and get full output from the amp and the input
> SWR remains flat on SSB.
> When the problem takes place on CW or Tune I still get full output from
the
> amp but high input SWR.
> IC shows under 20 amps even at high SWR on CW.
> Questions:
> Why only in CW?
> Could it be the meter on the OMNI V getting RF?
> Has anyone had this experience?
> What is causing this problem?
> Does the OMNI V automatically fold back output as some of the other brands
or
> will it keep pumping out power even at high SWR causing damage to the
finals?
> Thanks in advance.
> Dan/N4VET
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>