TenTec
[Top] [All Lists]

Re: [TenTec] Omni D

To: tentec@contesting.com
Subject: Re: [TenTec] Omni D
From: Able2fly@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 4 Jun 2005 22:28:03 EDT
List-post: <mailto:tentec@contesting.com>
 
In a message dated 6/4/2005 9:57:20 P.M. Eastern Daylight Time,  
longpond@downeast.net writes:

Just picked up an Omni D series B and need to know what pot is the  
adjustment for the S meter.  No book as yet.  Jim K1QCF
...................................................................


Jim,
 
The adjustment procedure goes like this:
 
Remove top cover. Apply 50 uV signal at 14,1 MHz to antenna terminal  and 
adjust RESONATE control and MAIN TUNING for S-Meter peak.  Set pot R20 on the 
IF-AGC board for S-9 reading. ( Just forward of the 8  pole xtal filter) 
 
Bill  K3UJ






_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>