Tim,
The Orion will never display the actual transverter frequency. My N4PY
Orion control program has full transverter configuration setup to allow the
program to display the correct frequency and automatically reduce the Orion
output power to the correct drive level. You can use any transverter with
my program and it will work properly. See my webpage at www.n4py.com for
more information on my program.
73,
Carl Moreschi N4PY
Franklinton, North Carolina
n4py@earthlink.net
----- Original Message -----
From: <k3hx@juno.com>
To: <tentec@contesting.com>
Sent: Tuesday, July 19, 2005 9:28 AM
Subject: [TenTec] Transverter Question
>
> Do the Ten_Tec transverters for the Orion cause the Orion's display
>
> to read the actual output frequency.
>
> If I get the 6 meter TT transverter, will the display say: 50.100?
>
> Should I opt for the Elcraft of DEMI, what software is used to cause
>
> the display to read the actual output frequency?
>
> 73
>
> Tim K3HX
>
>
>
> ___________________________________________________________________
> Try Juno Platinum for Free! Then, only $9.95/month!
> Unlimited Internet Access with 250MB of Email Storage.
> Visit http://www.juno.com/value to sign up today!
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|