| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Using Wavetek test equipment |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 19 Aug 2005 19:04:39 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
It has an internal signal source, which the int ext sw controls. Make sure the internal source has not been pulled for some reason, gets DC, etc. or the INT EXT sw might be bad in INT position. What load are you trying to drive? Stuart K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Sorry for the broadcast message, Don Rasmussen |
|---|---|
| Next by Date: | [TenTec] Wanted, Michael - VE3MKX |
| Previous by Thread: | [TenTec] Using Wavetek test equipment, J. Reed |
| Next by Thread: | Re: [TenTec] Using Wavetek test equipment, J. Reed |
| Indexes: | [Date] [Thread] [Top] [All Lists] |