[TenTec] Fw: Omni VI + Tuning

[Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>]

> Reseat the connector from the rotary encoder.  This is connector 98 on the
> logic board.
>
> While you are in there, carefully unplug each connector and the re-connect 
> same.  A lot of these carry very low level signals and any oxidation will 
> cause signal interruption. As to using contact cleaner, I am always very 
> careful of what and how much and where I use it.  Excessive amounts can 
> cause more problems than it corrects.
>
> 73
> Bob, K4TAX
>
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec