TenTec
[Top] [All Lists]

Re: [TenTec] ORION Inrad 600 CPS Roofing filter (NIB) Available

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] ORION Inrad 600 CPS Roofing filter (NIB) Available
From: Barry Gross <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 27 Dec 2005 11:51:39 -0500
List-post: <mailto:tentec@contesting.com>
Thanks Rick - that would explain the new 1.8Khz filter as well.

73
Barry

On 12/27/05, NJ0IP <Rick@dj0ip.de> wrote:
>
> Barry, I recall "hearing" that the new filters are a different size than
> the
> old ones.  If that is correct, that would mean they are not
> interchangeable.
>
> 73
> Rick
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Barry Gross
> Sent: Tuesday, December 27, 2005 8:31 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] ORION Inrad 600 CPS Roofing filter (NIB) Available
>
> On 12/27/05, Neal Campbell <nealk3nc@peoplepc.com> wrote:
> >
> > I understood the roofing filters were different  in the O2!
> >
>
> Many Orion 1 cw enthusiasts are using the Inrad 762 filter (600hz 4-pole)
> in
> the Orion 1's 1000hz slot.
>
> Again, is there info indicating that the Inrad 762 won't work/fit in the
> Orion 2 600hz slot?  Perhaps the pin config has changed for the O2 filter
> slots?
>
> 73, Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>