TenTec
[Top] [All Lists]

Re: [TenTec] Paragon Questions

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon Questions
From: joel hallas <jrhallas@optonline.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 14 Jan 2006 18:06:28 -0500
List-post: <mailto:tentec@contesting.com>
I used a 10D for some time, but found that I had a problem with hum 
apparently induced from the transformer in the TT ps directly to the 
coils of the dynamic mic! If I moved the power supply about 5 feet from 
the mic, or if I didn't use any compression it wasn't a problem.

Since I like the look and feel of the of the 10D and G stand, I 
eventually put a Heil HC-5 element in the 10D case (with a bit of 
packing foam behind to keep in place) and have been happy ever since. I 
also had a 705 and that worked fine, but in some comparitive tests (see 
Dec 03 QST review of the Heil ProSet+), we decided that the HC-5 was 
better with my voice and the 705 with Nancys's (W1NCY), so the HC-5 went 
into the 10D and the 705 is now part of the W1NCY IC-718 station.

I have enjoyed the Paragon a lot in the years since I've had it (it 
replaced my TT Corsair in perhaps 1998). The one thing you want to 
remember is that unlike the Omnis, it doesn't have a tight roofing 
filter (VHF first IF), so if the going gets tough hit the receive 
attenuator!

GL and enjoy!

73, Joel Hallas, W1ZR

w8au@sssnet.com wrote:

>At 12:24 PM 1/14/06, Graham Wright wrote:
>  
>
>>My favourite mic is a Shure 444 - super audio with this radio, but you
>>could also use a TT 705 desk mic or 701 hand mic.
>>    
>>
>
>Another good one (on Paragon) is the Astatic 10D dynamic.
>
>w8au
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>  
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>