TenTec
[Top] [All Lists]

Re: [TenTec] Help with Orion I

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Help with Orion I
From: "Henry Pfizenmayer" <pfizenmayer@worldnet.att.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 21 Jan 2006 19:47:08 -0700
List-post: <mailto:tentec@contesting.com>
Didn't someone on this list talk about a battery that kept the RAM alive ?? 
Could that have anything to do with the problem ?  I would think a ram clear 
and master reset would but maybe if the battery is dead ?????

 Hank K7HP
----- Original Message ----- 
From: "Charlie Hugg" <hug-a-bug1@cox.net>
To: <TenTec@contesting.com>
Sent: Saturday, January 21, 2006 9:24 AM
Subject: [TenTec] Help with Orion I


>I just acquired an Orion I from a friend who only used it about 6 hours
> before packing it up for a move 15 months ago. He never got around to
> unpacking it after the move and I talked him into selling it to me.   When 
> I
> got it home and turned it on, I heard some static from the speaker for a 
> few
> seconds and then nothing. Nothing that I have been able to do will produce
> any noise from the speaker and there is no movement in the analogue S 
> meter
> either. The Display works fine and all the controls appear to work, except
> the AF controls, although I do see the audio level indicators on the 
> display
> move across the screen as I turn the audio up. I do get readings on the
> Sweep display like it is receiving signals. But they are not getting to 
> the
> S-Meter or the speaker. I did a Master Reset but no help. I have been
> through every menu item. All check out.  I have not tried to transmit yet.
> I have the speaker turned on in the Audio Menu. I a VFO and Antenna 
> assigned
> to the Main or Sub Receiver as required.
> I have been through the manual three times. I am pretty sure that I have 
> all
> the Menue Items and Controls set correctly.
> I took the top off and checked  the filters. They are all in place. All
> cables look plugged in correctly.
> The only thing that I have found in the manual that might even come close 
> to
> causing a problem like I have described is a reference to the need to  use 
> a
> Stereo Plug if one uses Headphones. Appearenty if one uses a Mono Plug, it
> can cause damage to the radio.  I don't use ear phones and did not plug
> anything into this jack. So I know that is not the problem.  I am using 
> the
> internal speaker.
> Any ideas from the group? I am still hoping that it is operator problem
> rather than problems with the radio.
> Thanks. Charlie Hugg, K5MBX
> ________________________________
> See my Signal/One, Collins & Drake
> Photo Galleries and my Hallicrafters
> Virtual Museum at http://hug-a-bug.com
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>