TenTec
[Top] [All Lists]

Re: [TenTec] openwire feed OT

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] openwire feed OT
From: jerome schatten <romers@shaw.ca>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 01 Feb 2006 10:02:33 -0800
List-post: <mailto:tentec@contesting.com>
Why would you not connect also the shields together on the outside?

jerome - va7vv


Darwin, Keith wrote:
>  To feed open wire through a wall - use coax.  But not like you think.
> 
> Get 2 pieces of coax, equal in length.  Route them through the wall,
> connect center conductor only, one to each leg of the ladder line.
> Then, inside the shack, short the coax shields together and continue the
> run to your shack with ladder line.  There you have a coax cable based
> wall through method.
> 
> Or maybe continue with the parallel coax right to the in-shack coupler.
> 
> - Keith KD1E -
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>