On the O2 go to "menu", "other" and at the bottom of the list you will find
a line item to select the source of the "line out" and he last line is "line
out level" where you can select "low", "medium", "high".
Tom, W7QF
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of RaySoifer@cs.com
> Sent: Tuesday, February 14, 2006 21:20
> To: tentec@contesting.com
> Subject: Re: [TenTec] Another RTTY story
>
> In a message dated 2/15/06 1:55:44 AM GMT Standard Time,
> wb5hak@duracom.net
> writes:
> > how do you set the level of audio out on the AUX port?? I
> cannot for
> > the life of me find it, unless the main AF control controls it, but
> > that wouldn't be normal for a "line out" output.
> >
>
> I can't find a control for that either. It looks to be a
> fixed-level output, since the AF output control does not
> affect it. So, I use the computer's mic gain setting as the
> RX audio level control. The O2 provides enough output for my
> computer to work in that mode, although there isn't enough
> audio output to use the computer's line input jack.
>
> Hope this helps.
>
> 73,
>
> Ray W2RS
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|