TenTec
[Top] [All Lists]

Re: [TenTec] Orion1 Tuner on TX port 2

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Orion1 Tuner on TX port 2
From: "Grant Youngman" <nq5t@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 18 Feb 2006 17:37:08 -0600
List-post: <mailto:tentec@contesting.com>
No, sorry, I missed the Port 2 comment in the subject line.

It only works on ANT 1

Grant/NQ5T 

> -----Original Message-----
> From: tentec-bounces@contesting.com 
> [mailto:tentec-bounces@contesting.com] On Behalf Of CATFISHTWO@aol.com
> Sent: Saturday, February 18, 2006 3:06 PM
> To: tentec@contesting.com
> Subject: Re: [TenTec] Orion1 Tuner on TX port 2
> 
>  
> In a message dated 2/18/2006 1:04:11 P.M. Pacific Standard 
> Time, w2wg@comcast.net writes:
> 
> Grant-
> 
> Thanks. It is enabled.  I don't see anything about  enabling 
> on a port, though.  In any event with it set to enabled,  
> punching the tune button
> results in it tuning on ANT 1 but not ANT 2.   Does yours 
> tune on both ports?
> 
> Bob W2WG
> 
> 
> 
> =========================
>  
> seems to me it only tunes ant 1.. not both
>  
> tom N6AJR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>