The DSP speech processing is indeed RF and is done in software functionally
after the balanced modulator but before the TX equalizer. As a result very
impressive compression is achieved (I see average power jumping from about
150 watts to over 800 watts at higher settings) without any artifacts or
distortion. I measured a deliberate audio overdrive (red LED on constantly)
and found that the junk and intermods you would expect are 60 dB down from
full power output. Truly amazing performance. Nothing even close to this
performance on the market.
Forget any outboard speech compressor. It cannot even come close to the one
built into the Orion II.
73, Tom, W7QF
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of Glassrus
> Sent: Sunday, February 19, 2006 20:46
> To: 'Discussion of Ten-Tec Equipment'
> Subject: [TenTec] Orion Speech Compressors
>
> Can someone explain to me the type of speech compressor used
> in the Orion, and Orion II. The manual describes it as a RF
> compression type, but goes into no detail.
>
> I have a TT 234 RF clipping compressor. Would it be
> beneficial to use this instead of the Orion compressor?
>
> TNX
> Paul N8NOV
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|