Dunno about that. My Ten Tec processor doesn't have to have a multi-thousand
dollar radio attached to it. Works fine with the 544.
mike
k5wmg
one watt all the time
---------- Original Message ----------------------------------
From: "Thomas Jednacz" <tjednacz@ieee.org>
Reply-To: tjednacz@ieee.org,
Date: Tue, 21 Feb 2006 20:42:29 -0500
>The DSP speech processing is indeed RF and is done in software functionally
>after the balanced modulator but before the TX equalizer. As a result very
>impressive compression is achieved (I see average power jumping from about
>150 watts to over 800 watts at higher settings) without any artifacts or
>distortion. I measured a deliberate audio overdrive (red LED on constantly)
>and found that the junk and intermods you would expect are 60 dB down from
>full power output. Truly amazing performance. Nothing even close to this
>performance on the market.
>
>Forget any outboard speech compressor. It cannot even come close to the one
>built into the Orion II.
>
>73, Tom, W7QF
>
>> -----Original Message-----
>> From: tentec-bounces@contesting.com
>> [mailto:tentec-bounces@contesting.com] On Behalf Of Glassrus
>> Sent: Sunday, February 19, 2006 20:46
>> To: 'Discussion of Ten-Tec Equipment'
>> Subject: [TenTec] Orion Speech Compressors
>>
>> Can someone explain to me the type of speech compressor used
>> in the Orion, and Orion II. The manual describes it as a RF
>> compression type, but goes into no detail.
>>
>> I have a TT 234 RF clipping compressor. Would it be
>> beneficial to use this instead of the Orion compressor?
>>
>> TNX
>> Paul N8NOV
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|