Ken,
I just got home and looked at the Orion; When you press and hold the
menu button, does it indicate "V2 mod confirmed"? This is something
else to consider as if it does not indicate this, then further work is
required.
Good luck and let us know what you find.
Robb..., NØRU
----- Original Message -----
From: "Ken Brookner" <kenb@brookner.com>
To: <tentec@contesting.com>
Sent: Wednesday, February 22, 2006 1:34 PM
Subject: Re: [TenTec] orion sweep mod, questions...
> hi robb,
>
> thanks -- that's exactly how it acts, like I didn't plug a cable back in
> properly. but I've checked that several times. won't hurt to check again
> though. I should mention that everything else seems to be working
> properly.
> just noise and no signals on the sweep...
>
> I noted that the "main" and "sub" connectors are right together. I will
> double check that this evening.
>
> thanks!
> kenb
>
> --------------------
>> > Ken,
>>
>> By chance, did you plug the logic board coax into the
>> "main" connector, not the "sub" jack? I noticed that
>> these connectors are close to each other and by not
>> being careful, one could easily make an error.
>> Just a thought as I did the mod over the weekend and
>> agree that the documentation was excellent.
>> Good luck, Robb N0RU
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|