To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] Voltages on 262G power supply |
From: | w8au@sssnet.com |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Mon, 27 Feb 2006 15:40:53 -0500 |
List-post: | <mailto:tentec@contesting.com> |
At 03:03 PM 2/27/06, James C. Owen, III wrote: > I think you should crank the voltage up to the rated 13.9V. >I'm not familar with the 262G supply but I assume it's like most >others in that is has a voltage adjustment pot inside. There is no voltage adjust inside. Only a crowbar adjustment for overcurrent. However, you can jack up the voltage to 13.8 or so by adding a series diode or two to the reference diode already there. (.6V for each added silicon diode) Works fine. Perry w8au _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Changing a lightbulb, Reed O. Krenn |
---|---|
Next by Date: | [TenTec] For sale, ron |
Previous by Thread: | Re: [TenTec] Voltages on 262G power supply, James C. Owen, III |
Next by Thread: | [TenTec] re Orion II and Centurionj, Rob Atkinson, K5UJ |
Indexes: | [Date] [Thread] [Top] [All Lists] |