TenTec
[Top] [All Lists]

Re: [TenTec] Orion II and MixW cat issues

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion II and MixW cat issues
From: "jack" <jfriend31@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 16 Apr 2006 16:52:02 -0600
List-post: <mailto:tentec@contesting.com>
i use LOGic8 with MixW. an entered call in MixW automatically goes to 
LOGic8. since LOGic8 reads my Orion, there is no problem of the sort you 
note. LOGic8 will also change bands, frequencies, etc without adversely 
affecting any of the normal functions of the Orion.
jack
ak7o

----- Original Message ----- 
From: "Douglas Shock" <douglas.shock@gmail.com>
To: <TenTec@contesting.com>
Sent: Sunday, April 16, 2006 3:29 PM
Subject: [TenTec] Orion II and MixW cat issues


> Anyone experiancing issues with mixw and the Orion II performance when
> servicing interupts and using the cat interface from MixW?
>
> The only speed I can get anything to work at is 57600, but at this baud
> rate, the perfornace of the Orion II sweep is at a standstill and I have 
> to
> push buttons 3 to 4 times to get the Orion II to respond.
>
> When I change bands from within MiXw I can hear the radio change but the
> freq. readout doesn;t change.
>
> Any Ideas?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>