TenTec
[Top] [All Lists]

Re: [TenTec] Non-digital Ten-Tec transceivers

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Non-digital Ten-Tec transceivers
From: Tod Glenn <n7jqw@cordite.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 10 Jun 2006 17:50:53 -0600
List-post: <mailto:tentec@contesting.com>
On Jun 10, 2006, at 3:29 PM, Geoffrey S. Mendelson wrote:

> On Sat, Jun 10, 2006 at 11:21:31AM -1000, Ken Brown wrote:
>
>> I'm toying with the idea of getting a "non digital" rig. I'd like to
>> have most of the capability of an Omni VI without any PLLs. Just
>> crystals and a PTO. I don't care if it can operate in any modes other
>> than CW. I don't think I'd be satisfied with a direct conversion
>> receiver. What Ten-Tec rigs would fill these requirements?
>
> There were many of them, BUT, most of them had digital displays.  
> The actual
> radio was analog, but the display was digital.
>
> Off the top of my head:
>
> Original Argonauts: 505, 509, 515.
> Tritons: I,II IV, IV digital
> Original Omnis (not the VI)
> Corsair and Corsair II.
> Century 21, 22 and 22 digital
> Deltas
>
> Was the Scout? I thought it had a PTO with a digital display, and a
> microprocessor circuit to correct drift.


Argosy and Argosy II.

----
Tod Glenn
N7JQW
NAQCC #1283
SKCC #1444
FISTS #12134
ARCI #12420
n7jqw@cordite.com



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>