I do this all the time with my N4PY Orion control program and my DX Spots
program. By running the Orion completely under software control, all these
problems are gone.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "George" <goofyham@highstream.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, September 28, 2006 7:41 AM
Subject: Re: [TenTec] orion2 bandstacking?
> Is there anyone using a logging program that has packet spots that you can
> click on and change the frequency and mode/width of the Orion2?
> I find that if I set up my band stacking registers to my liking the spot
> clicking uses one of these registers and screws up my stacking frequency
> setup.
> Invariably, I want to go to my favorite band/frequency and the registers
are
> screwed up by the spot clicking.
> In my opinion I think Ten Tec should visit the use of the stacking
registers
> for spot clicking. I don't think the Orion2 should use the registers for
> spot clicking. I also don't think Ten Tec gave much thought to users doing
> remote control of the Orion2.
> By the way, an indication of which stacking registers is in use on the
> screen.
> Anyone else have this problem?
> Thanks.
> George
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|