TenTec
[Top] [All Lists]

Re: [TenTec] Argosy 525 Tuning LED

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>,<jt.w6fo@gmail.com>
Subject: Re: [TenTec] Argosy 525 Tuning LED
From: "Mike Hyder -N4NT-" <Mike_N4NT@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 28 Sep 2006 22:00:43 -0400
List-post: <mailto:tentec@contesting.com>
I'm not sure but would think it operates like the analog dials on the 
rest of the Ten-Tecs.  If so, the dial's movement depends on an elastic 
"bungee" section of the dial cord.  Over time, that elastic loses its 
ability to pull the pointer to the end of the dial.  It is NOT necessary 
to re-string the whole dial cord, just replace that bungee section. 
When I last did it, Ten-Tec had sent me some little metal clips to use 
to join the bungee cord to the plain cord.  Ten-Tec will probably send 
you some or the guys here can advise you.  Seems they buy that elastic 
cord in the sewing section at Wal-Mart, etc.

You will need to remove the front panel to access that cord.  Take all 
knobs off and remove the screws from the corners of the front panel.
A Hint: when replacing the screws in the corners of the front panel, DO 
NOT overtighten as the panel is easily cracked by so doing.
Another hint: when replacing the dial skirt, it is most easily done by 
making a loop of dental floss to remove tension from the D-spring.

73, Mike N4NT

----- Original Message ----- 
From: "JT Croteau" <jt.w6fo@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, September 28, 2006 8:44 PM
Subject: [TenTec] Argosy 525 Tuning LED


|I have an Argosy 525 and the tuning LED bar is stuck and never moves.
| Anyone know how difficult of a fix this is?
|
| Thanks
|
| --
| JT Croteau - W6FO - Canton, GA
| ARS #2,147 | NoGA-QRP | SEDXC | SECC | ARRL 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>