In a message dated 10/4/2006 2:16:27 P.M. Eastern Daylight Time,
des.n4in@gmail.com writes:
Paul at TT, knew exactly what it was when I called this AM. The speaker
magnet is not shielded and is causing a component on the board immediately
below it to malfunction. I presume it is in the audio chain. Replace that
component, a choke, or shield the speaker magnet and problem solved.
Replace it with WHAT? Will TT provide a shield or appropriate component (or
fix the problem?)
Bill
K3UJ
Paul at TT, knew exactly what it was when I called this AM. The speaker
magnet is not shielded and is causing a component on the board immediately
below it to malfunction. I presume it is in the audio chain. Replace that
component, a choke, or shield the speaker magnet and problem solved. I
removed the speaker as a test and problem solved, no further issues.
73,
David, N4IN
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Roy Koeppe
Sent: Wednesday, October 04, 2006 11:54 AM
To: Ten Tec Reflector
Subject: Re: [TenTec] Orion-2 slight problem...
N4IN asked about:
"...then gradually a hum will start in on the audio...(etc.)"
Is it 60 Hz or 120 Hz or something else? If power feeding the rig is
pure DC, then how do you account for 'hum'? Something oscillating
within, or maybe hum being picked up from an external source such as a
power transformer too near to the rig? Please describe.
73, Roy K6XK
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|