Yep the axle grease dries out and gets hard. Use a snythetic grease and that
will not happen.
Bruce
WA2USA@aol.com wrote: Dave, I hope you don't mind me writing to you in response
to your email to
another ham radio operator who owns a Ten Tec Corsair II.
But I couldn't help but read where you gave some advice to Steve, N0TU,
about rebuilding the PTO of his rig to improve the receiver.
I just wanted to make sure I understood what was happening. You see, my
Corsair II is getting mushy on receive, meaning I experience warble on
signals,
which settle out after the rig has been on for a while.
You mentioned to call John at Ten Tec to get a rebuild kit for the PTO. Do
you know what typically goes bad in the PTO circuit to cause the warble on
signals? And do you know John's last name?
Any help you can give me will be appreciated.
Take care and best 73.
de Dennis - WA2USA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---------------------------------
Do you Yahoo!?
Get on board. You're invited to try the new Yahoo! Mail.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|